Clone Sweep
Toolbar Icon
Command Line xsCloneSweep
Menu n/a
  Free License No

Description
  Clones a surface by extracting cross-sections into another profile(s).

Steps
  1. Download this file and open it in Rhinoceros 6®.
2. Run the command 'Clone Sweep'.
3. Select the green curve as the origin rail.
4. Select the red surface as the sweep to clone.
5. Select the blue curves as the destination rails.
6. Drag the origin rail start point by clicking near the curve direction arrow. 7. Do the same for the destination rails.
8. Drag the section points by clicking over the point.
9. Flip the curve directions as necessary clicking in the opposite side of the curve direction arrow.
10. Press Enter and in the dialogue set the curve parameters.

Command-line options
  OutputProperties: If is set to 'Input', the result object(s) will be have the same properties of the selected object.
NrOfSections: Number of cross-sections used to remap the sweep at the destination rails.
Normal: The plane Z direction used to intersect the cross-sections.
Preview: Enables or disables the command 'draft' result.

Notes
  - For open curves, you can change the direction by clicking over the curve direction arrow.
- For closed curves, you can change the direction by clicking in the opposite side of the curve direction arrow.
- For closed curves, you can change the curve start point by clicking over the curve direction arrow and drag it to the new location.
- The cross-section points can be changed by clicking over the point and drag it to the new location:
   - If the point is at the origin rail, the points at the destination rail(s) will also change.
   - If the point is at any destination rail, only the selected point changes.

© tools4rhino